mirror of
				https://github.com/esphome/esphome.git
				synced 2025-10-30 06:33:51 +00:00 
			
		
		
		
	Add IP101 support to Ethernet component (#3751)
This commit is contained in:
		| @@ -31,6 +31,7 @@ EthernetType = ethernet_ns.enum("EthernetType") | ||||
| ETHERNET_TYPES = { | ||||
|     "LAN8720": EthernetType.ETHERNET_TYPE_LAN8720, | ||||
|     "TLK110": EthernetType.ETHERNET_TYPE_TLK110, | ||||
|     "IP101": EthernetType.ETHERNET_TYPE_IP101, | ||||
| } | ||||
|  | ||||
| eth_clock_mode_t = cg.global_ns.enum("eth_clock_mode_t") | ||||
|   | ||||
| @@ -6,6 +6,7 @@ | ||||
| #ifdef USE_ESP32_FRAMEWORK_ARDUINO | ||||
|  | ||||
| #include <eth_phy/phy_lan8720.h> | ||||
| #include <eth_phy/phy_ip101.h> | ||||
| #include <eth_phy/phy_tlk110.h> | ||||
| #include <lwip/dns.h> | ||||
|  | ||||
| @@ -33,6 +34,7 @@ EthernetComponent *global_eth_component;  // NOLINT(cppcoreguidelines-avoid-non- | ||||
|   } | ||||
|  | ||||
| EthernetComponent::EthernetComponent() { global_eth_component = this; } | ||||
|  | ||||
| void EthernetComponent::setup() { | ||||
|   ESP_LOGCONFIG(TAG, "Setting up Ethernet..."); | ||||
|  | ||||
| @@ -52,6 +54,10 @@ void EthernetComponent::setup() { | ||||
|       memcpy(&this->eth_config_, &phy_tlk110_default_ethernet_config, sizeof(eth_config_t)); | ||||
|       break; | ||||
|     } | ||||
|     case ETHERNET_TYPE_IP101: { | ||||
|       memcpy(&this->eth_config_, &phy_ip101_default_ethernet_config, sizeof(eth_config_t)); | ||||
|       break; | ||||
|     } | ||||
|     default: { | ||||
|       this->mark_failed(); | ||||
|       return; | ||||
| @@ -76,6 +82,7 @@ void EthernetComponent::setup() { | ||||
|   err = esp_eth_enable(); | ||||
|   ESPHL_ERROR_CHECK(err, "ETH enable error"); | ||||
| } | ||||
|  | ||||
| void EthernetComponent::loop() { | ||||
|   const uint32_t now = millis(); | ||||
|  | ||||
| @@ -115,16 +122,39 @@ void EthernetComponent::loop() { | ||||
|       break; | ||||
|   } | ||||
| } | ||||
|  | ||||
| void EthernetComponent::dump_config() { | ||||
|   std::string eth_type; | ||||
|   switch (this->type_) { | ||||
|     case ETHERNET_TYPE_LAN8720: | ||||
|       eth_type = "LAN8720"; | ||||
|       break; | ||||
|  | ||||
|     case ETHERNET_TYPE_TLK110: | ||||
|       eth_type = "TLK110"; | ||||
|       break; | ||||
|  | ||||
|     case ETHERNET_TYPE_IP101: | ||||
|       eth_type = "IP101"; | ||||
|       break; | ||||
|  | ||||
|     default: | ||||
|       eth_type = "Unknown"; | ||||
|       break; | ||||
|   } | ||||
|  | ||||
|   ESP_LOGCONFIG(TAG, "Ethernet:"); | ||||
|   this->dump_connect_params_(); | ||||
|   LOG_PIN("  Power Pin: ", this->power_pin_); | ||||
|   ESP_LOGCONFIG(TAG, "  MDC Pin: %u", this->mdc_pin_); | ||||
|   ESP_LOGCONFIG(TAG, "  MDIO Pin: %u", this->mdio_pin_); | ||||
|   ESP_LOGCONFIG(TAG, "  Type: %s", this->type_ == ETHERNET_TYPE_LAN8720 ? "LAN8720" : "TLK110"); | ||||
|   ESP_LOGCONFIG(TAG, "  Type: %s", eth_type.c_str()); | ||||
| } | ||||
|  | ||||
| float EthernetComponent::get_setup_priority() const { return setup_priority::WIFI; } | ||||
|  | ||||
| bool EthernetComponent::can_proceed() { return this->is_connected(); } | ||||
|  | ||||
| network::IPAddress EthernetComponent::get_ip_address() { | ||||
|   tcpip_adapter_ip_info_t ip; | ||||
|   tcpip_adapter_get_ip_info(TCPIP_ADAPTER_IF_ETH, &ip); | ||||
| @@ -213,17 +243,21 @@ void EthernetComponent::start_connect_() { | ||||
|   this->connect_begin_ = millis(); | ||||
|   this->status_set_warning(); | ||||
| } | ||||
|  | ||||
| void EthernetComponent::eth_phy_config_gpio() { | ||||
|   phy_rmii_configure_data_interface_pins(); | ||||
|   phy_rmii_smi_configure_pins(global_eth_component->mdc_pin_, global_eth_component->mdio_pin_); | ||||
| } | ||||
|  | ||||
| void EthernetComponent::eth_phy_power_enable(bool enable) { | ||||
|   global_eth_component->power_pin_->digital_write(enable); | ||||
|   // power up takes some time, datasheet says max 300µs | ||||
|   delay(1); | ||||
|   global_eth_component->orig_power_enable_fun_(enable); | ||||
| } | ||||
|  | ||||
| bool EthernetComponent::is_connected() { return this->state_ == EthernetComponentState::CONNECTED; } | ||||
|  | ||||
| void EthernetComponent::dump_connect_params_() { | ||||
|   tcpip_adapter_ip_info_t ip; | ||||
|   tcpip_adapter_get_ip_info(TCPIP_ADAPTER_IF_ETH, &ip); | ||||
| @@ -250,6 +284,7 @@ void EthernetComponent::dump_connect_params_() { | ||||
|   ESP_LOGCONFIG(TAG, "  Link Up: %s", YESNO(this->eth_config_.phy_check_link())); | ||||
|   ESP_LOGCONFIG(TAG, "  Link Speed: %u", this->eth_config_.phy_get_speed_mode() ? 100 : 10); | ||||
| } | ||||
|  | ||||
| void EthernetComponent::set_phy_addr(uint8_t phy_addr) { this->phy_addr_ = phy_addr; } | ||||
| void EthernetComponent::set_power_pin(GPIOPin *power_pin) { this->power_pin_ = power_pin; } | ||||
| void EthernetComponent::set_mdc_pin(uint8_t mdc_pin) { this->mdc_pin_ = mdc_pin; } | ||||
| @@ -257,12 +292,14 @@ void EthernetComponent::set_mdio_pin(uint8_t mdio_pin) { this->mdio_pin_ = mdio_ | ||||
| void EthernetComponent::set_type(EthernetType type) { this->type_ = type; } | ||||
| void EthernetComponent::set_clk_mode(eth_clock_mode_t clk_mode) { this->clk_mode_ = clk_mode; } | ||||
| void EthernetComponent::set_manual_ip(const ManualIP &manual_ip) { this->manual_ip_ = manual_ip; } | ||||
|  | ||||
| std::string EthernetComponent::get_use_address() const { | ||||
|   if (this->use_address_.empty()) { | ||||
|     return App.get_name() + ".local"; | ||||
|   } | ||||
|   return this->use_address_; | ||||
| } | ||||
|  | ||||
| void EthernetComponent::set_use_address(const std::string &use_address) { this->use_address_ = use_address; } | ||||
|  | ||||
| }  // namespace ethernet | ||||
|   | ||||
| @@ -17,6 +17,7 @@ namespace ethernet { | ||||
| enum EthernetType { | ||||
|   ETHERNET_TYPE_LAN8720 = 0, | ||||
|   ETHERNET_TYPE_TLK110, | ||||
|   ETHERNET_TYPE_IP101, | ||||
| }; | ||||
|  | ||||
| struct ManualIP { | ||||
|   | ||||
		Reference in New Issue
	
	Block a user